What are the key points of shot blasting machine maintenance introduced by the shot blasting machine manufacturer of Wuxi IDEAL Machinery Manufacturing Co., Ltd?

What should be done to maintain the shot blasting machine? The manufacturer of the shot blasting machine thinks it is necessary to start from the practical experience of the maintenance personnel of the shot blasting machine. The maintenance of the electric actuator of the shot blasting machine should adopt different key maintenance methods according to its different use periods. We should generally do the following:

1； Timely lubrication: the motor and transmission parts of the electric actuator of the shot blasting machine need to be lubricated with lubricating oil, and the viscosity of the lubricating oil changes with the oil temperature. The viscosity is too low, and the wear of gear and other transmission parts increases; The viscosity is too high and the action is poor. Therefore, punctual lubricating oil can extend its service life.

2； Improve the working environment: in order to ensure the reliability of the electric actuator of the shot blasting machine, it is necessary to ensure that it works in a suitable working environment to prevent the appearance of other environmental factors such as humidity from forming short circuit or other defects.

3； Check on time: check on time to find the hidden dangers of accidents in the operation in time. At least the search of defect elements will help to prevent detours.

4； Deal with the defect account: each defect handled shall be recorded in detail, including the defect phenomenon, defect analysis and search process, defect cause, treatment method, prevention method, etc. This not only provides reference value for dealing with similar problems in the future, but also improves the level of finding defect elements through the defect curve to achieve the effect of getting twice the result with half the effort.

The engine pipe joint of the shot blasting machine leaks oil. Pipe joints include conical joint and hollow bolt pipe joint. The conical joint pipe joint includes two ends of the pressure gauge, one end of the gasoline pipe, two ends of the high pressure oil pipe and the pipe joint from the fuel coarse filter to the fuel transfer pump. If the high pressure oil pipe joint is worn, deformed or cracked due to the start of the shot blasting machine, it can be sawed off and replaced with a good joint for welding. If the low pressure oil pipe joint is damaged, the bell mouth can be sawed off and made from scratch. If the thread is damaged, it should be corrected or replaced with a new one. The banjo bolt pipe joint includes the fuel coarse and fine filters and the low pressure fuel delivery pipe joint number of the fuel injection pump. If the gasket is damaged or the device is uneven, it can be replaced with plastic gasket, or leveled with assorted file, or polished with abrasive paper, or milled with a milling machine in severe cases. If there is a pull mark on the plane of the pipe joint device, the plane and gasket of the joint device can be smoothed with fine abrasive paper or oil stone; If there are impurities on the joint surface, pay attention to the cleanliness of the body when installing the device, and tighten the joint fixing bolts evenly.

If you want to know more about relevant knowledge, you can browse our website, and we will provide you with more professional information!