The manufacturer of the shot blasting machine will talk with you in detail about how to maintain the shot blasting machine.

The following is introduced to you by the shot blasting machine manufacturer:

After purchase, the shot blasting machine must undergo routine maintenance. The longer the shot blasting machine runs, the more workpieces it will handle. If it does not undergo planned maintenance, its service life will be affected. The shot blasting machine will be equipped with instructions. Therefore, it must be implemented according to the regulations specified in the instructions to correctly use the shot blasting machine, improve the productivity of shot blasting, and reduce the cost input.

Daily maintenance of shot blasting machine:

1. Check the main parts and accessories again and again, such as shot blaster, directional sleeve, shot wheel, side guard plate, impeller, blade and steel shot.

2. Check the electrical systems of the equipment to see if they are out of order or broken.

3. All parts of the shot blasting machine shall be lubricated regularly to ensure that the shot blasting effect is not poor due to a certain part.

4. Each guard board of the shot blasting machine should be checked every day to see if it is worn. If it is seriously damaged, it needs to be replaced.

5. Check all lines and stud screws to ensure that there is no looseness of lines and studs to avoid safety accidents.

6. The technical operator should evaluate the shot blasting effect, and how to adjust if the effect is not obvious.

7. The shot blasting machine has a strong surface treatment effect, and its normal and correct use can extend the service life of the shot blasting machine.

In the processing process of shot blasting machine, each shot is a process of constant wear and decrease, so the particle size of each shot is constantly changing. Because the hot spot changes with the grain size of the steel shot, in order to ensure the thermal grain size/ram matching gradually tends to the normal curve. If too much material is added at one time, the appearance of the casting will become fine immediately.

(1) Supplementary feeding shall be conducted regularly, and each feeding shall not exceed 10% of the total amount of steel shot. In the process of consumption, the grain size distribution of steel shot shall often be reviewed to ensure that the grain size distribution of steel shot remains unchanged, so as to ensure the liquidation efficiency and the fluctuation of casting surface quality.

(2) In the process of shot blasting machine processing, accurate adjustment and often introspection of the hot shot blasting head are the key elements to ensure the clearing efficiency and waste of capital, to ensure the normal task of the shot blasting separator, to ensure sufficient sand volume, and to develop the power of the shot blasting motor with greater restrictions.

(3) The clearing time can be controlled by removing the sand and oxide skin and exposing the metal body. The extended clearing time can certainly change the appearance fineness of the casting. But it has increased efficiency and cost.

The above is the content about the shot blasting machine shared this time. If you are interested in this topic or have different opinions, please communicate with us!