The manufacturer of the shot blasting machine will talk with you about the precautions and routine maintenance before using the shot blasting machine.

The following precautions before using the shot blasting machine are introduced by the shot blasting machine manufacturer and you:

Before using the shot blasting machine, the relevant contents of the equipment need to be understood clearly. Therefore, it is more accurate to install the device according to the instructions. Of course, if there are special staff from the manufacturer to install it, the effect will be better, and of course, the effect of application will be more guaranteed. Before planning work, you should be familiar with the operating procedures of the shot blasting machine. Only by knowing the procedures can you better implement the operation, and the equipment will be better cared for. Familiarity with the operating procedures of the equipment will also guarantee the use of the equipment. Therefore, we need to pay attention to the above problems before the actual operation. As long as these problems are handled properly, we can improve the life of the equipment and the manufacturing power of the enterprise.

Daily repair and maintenance of shot blasting machine:

1. Check whether the fixing bolts on the motor of the shot blasting machine and shot blasting machine are loose, and tighten them immediately if they are loose.

2. The wear condition of the wear-resistant parts in the power blaster and the guard plate in the shot blasting chamber, and the worn parts shall be replaced in time.

3. Whether the access door of shot blasting machine is closed tightly.

4. Check whether the limit switches and proximity switches are normal.

5. Check whether the operation of each signal indicator on the console is normal.

6. Check whether the total amount of shot material in the shot material bin is sufficient, and the shortage should be increased.

Monthly repair and maintenance of shot blasting machine:

1. Check and adjust the fan valve; 2. Adjust the looseness and verticality of the drive chain and lubricate it. 3. The belt of the fragrant wool bucket elevator is loose and vertical, and adjusted. Check the hopper bolts and tighten them. 4. Check the lubricating oil of the reducer. If it is lower than the regular oil level, add corresponding lubricating grease. 5. Check the contact conditions of each AC contactor and knife switch, and conduct soot blowing and cleaning. 6. Check whether the wires and electrical systems of the power and control parts are loose and fastened. 7. Check the wear and fixation of the fan and air duct.

Quarterly repair and maintenance:

1. Check the bearing and add lubricating grease. 2. Replace the lubricating grease for the shot blasting machine and the shot blasting motor. 3. Check the tightness of the fixing bolts and flanges of the motor, reducer, fan and three screw conveyors.

Annual repair and maintenance:

1. Overhaul the motor bearing, 2. Replace or weld the main chamber body guard plate, 3. Check the contact reliability of PLC and frequency converter, 4. Check whether the ammeter is accurate.

If you want to know more relevant knowledge, you can browse our website, and we will provide you with more professional information!