IDEAL005, introduction of sandblasting room:

The sandblasting room body is welded by steel plates, and its skeleton is a portal structure. The portal frames are connected by cross connecting rods, and the portal frames are installed on the ground with anchor bolts through installation blocks. The two sides of the portal frame are covered with pressed steel sheet, with a thickness of 0.5~0.8 mm, and the surface is painted. In order to improve the service life of the room, the wear-resistant rubber plate with a thickness of 6mm is pasted inside the room. The technical parameters of rubber sheet are: hardness 38IRHD, tensile strength 26.6 MPa, elongation 81%, tear strength 83%, wear index (wet) 108, temperature range 4-70 ℃.

Dust-proof lighting system shall be adopted for lighting, and the indoor illumination shall not be less than 650 lx at 1.5m above the ground. All doors leading to the sandblasting room are equipped with electrical interlocking devices to ensure that the sandblasting system will stop working when any door is opened. A warning light is set outside the door, and the light on indicates that sand blasting is in progress.

The floor in the sandblasting room adopts special honeycomb floor, and the size of each honeycomb floor is 500mm × 500 mm。 Each two rows of honeycomb floors form a honeycomb floor module along the length of the sandblasting room. After the abrasive falls into the honeycomb floor, the fan will suck it into the collection pipe through the material hole, and then suck it away from the collection pipe.