Today, Wuxi IDEAL Machinery will introduce Wuxi shot blasting machine. We all know that every machine has its life. If it is not used correctly or not repaired, it will cause a series of machine problems. What are the common problems of Wuxi shot blasting machine?

Wuxi shot blasting machine is a kind of processing skill that the steel sand and steel shot are dropped and impacted on the surface of the material at high speed by the shot blasting machine. Compared with other surface treatment skills, it is faster and more useful, and can be used for the casting process after partial retention or stamping.

1、 Damage and replacement of shot splitting wheel

The shot splitting wheel can be said to be a relatively simple and bad part in the shot blasting machine. If the shot splitting wheel is grinded to more than 1.5 cm, it must be replaced with a new one. If it is not replaced, then the machine's guard plate will be simply broken, so that it will not have such a good effect when finishing.

2、 Damage and replacement of impeller

The impeller usually needs to be checked for shaking at a specified time, and whether the roundness and focus of its disc are abnormal. If so, it should be replaced with a new one. If this problem is not handled in time, the shot blasting machine and liner will also be damaged.

3、 Inspection, replacement and innovation of sealing material of shot blasting machine

In order to prevent the shot from falling out, the outer cover and box of Wuxi shot blasting machine often use a piece of rubber to seal it, because this can ensure that there is no gap between the top guard plate of the shot blasting machine and the end guard plate of the side guard plate. In the process of mechanical operation, the bullet will overflow due to the effect of force, so it is important to replace the sealing gasket frequently.

4、 Inspection and replacement of end shield and side shield

Generally, in order to protect these two plates, they will be fixed inside the shot blasting machine, and can also protect the shot blasting case. The four trapezoidal bolts that make up the end guard plate will sometimes deform, so they need to be replaced. If the end guard plate is cracked or may be seriously dented, it should also be replaced. The combination between the top and bottom of the side guard plate is also local. If the fracture is serious, it should also be replaced. In addition, in order to prevent the side guard from falling, it should be firmly fixed with bolts in the outer concave groove.

If you want the shot blasting machine to have a longer service life and better work, you must pay more attention to prevent the causes of its defects, so as to ensure the normal operation of the machine!

This is the whole content of today. If you want to know more about Wuxi shot blasting machine, please pay attention to Wuxi Adier Machinery.