Today, Wuxi IDEAL Machinery will introduce Wuxi shot blasting machine. The effect of shot blasting machine is a kind of skill to deal with the surface. It can deal with all kinds of problems on the surface by throwing steel sand and steel shot at high speed. It can eliminate burrs, rust, contaminants, etc. on the surface. However, the shot blasting machine will encounter many problems in the process of operation, and solving these problems is the key to the operation of the shot blasting machine.

Wuxi shot blasting machine is mainly composed of four parts:

① The shot blaster usually uses a high-speed rotating impeller to shoot the shot in a certain direction under the effect of high centrifugal force. In the process of operation, some shot blasters can swing or move up and down at a certain viewpoint.

② Bullet collection, separation and transportation system.

③ The bearing body that enables the casting to continuously run and turn over in the process of shot blasting.

④ Dust removal system.

Sand blasting room: no deep pit is required (or pit is not required), low capital construction cost and short construction period.

The equipment of shot blasting finishing machine is mainly composed of shot blasting machine, wear-resistant rubber belt, auger, lifting, separator, feed conveyor, dust remover and finishing machinery.

1. Dress belt

Wuxi shot blasting machine has certain risks during operation. In order to prevent accidental injury and accidents, operators need to wear protective clothing and eye protection measures.

2. Value up to standard

During the operation of Wuxi shot blasting machine, the operator must pay attention to the values on the instruments on the panel. If the values are within the range of the normal target, the operator can operate the small crane to carry out the operation. If it is found that the individual values do not reach the normal target distance, it is necessary to immediately shut down, check the fault, and then start the operation normally after handling.

3. Abnormal

When the equipment is in operation, the operator should not be idle, but should carefully inspect whether there is abnormal noise or abnormal overheating of those parts. If abnormality is found and serious problems occur during operation, press the emergency stop button immediately, strike immediately for urgent repair, and cooperate with professional personnel to clean up equipment problems.

4. Dust collector

In the daily care of Wuxi shot blasting machine, the movement should be carried out in strict accordance with the maintenance in the equipment management, and the sundries in the dust remover should be carried out every week, so as not to affect the treatment of dust removal and the operation efficiency of the equipment.

In a large sense, the meaning of shot blasting machine lies in the improvement of equipment. If there is any defect, it should be found and remedied in time.

If you want to know more, you can read our website, and we will provide you with better information!