Introduction to IDEAL005 and JPG shot blasting machines:

The background of JPG shot blasting machine is that in the production process of large quantities of steel sand and steel shot, the quality of steel sand and steel shot cannot be guaranteed. The steel sand and steel shot can be dropped at high speed by shot blasting machine. In this process, the stains attached to the surface of steel sand and steel shot can be cleaned, so that the damage of steel sand and steel shot surface can be found in large quantities.

The main function of JPG type shot blasting machine is to effectively remove the burr and some large-scale rust on the surface of steel products by using the shot blasting machine. For steel production, the shot blasting machine is an inevitable equipment, and the use of the shot blasting machine for surface treatment of steel sand and steel shot is also an essential process, which is to remove the surface stain of steel sand and steel shot Rust and a necessary procedure for checking the surface integrity of products are essential.

Specific operation of JPG shot blasting machine:

1. For operators: the operators of the shot blasting machine must be strictly trained before the job, and after the job, they should also be regularly trained on the job, so that the operators can fully understand the characteristics and performance of the shot blasting machine;

2. About the instructions: after using the shot blasting machine and getting familiar with the shot blasting machine, you must not operate according to your own ideas. You must strictly operate according to the operation process of the instructions, use according to the methods in the instructions, and maintain the warranty;

3. For non-operators: non-operators should try not to touch easily, especially the control area of electrical switches. For the sake of safety, non-staff should try not to be in the working area of the shot blasting machine.

4. About equipment inspection: Before starting the machine, the operator must carefully check whether all switches in the control cabinet are properly installed at the specified position, whether there is any damage, and then start the machine after everything is OK. In order to avoid injury to machinery and equipment and equipment accidents.