Today, Wuxi IDEAL Machinery will introduce the shot blasting machine. There are many curved cooling channels and piston cavities in the engine body of the shot blasting machine. With the development of the automobile industry, the demand for engine castings is becoming higher and higher. The shot blasting machine also requires that the shot cannot be left in the engine cylinder. The useful recovery of the shot is still a manifestation of the safety and economy of the equipment.

1. Equipment use

This equipment is an auxiliary equipment specially designed and manufactured for shot blasting machine. It is located on the workpiece delivery line. Its primary purpose is to dump a few shot materials left in the casting cavity after shot blasting.

2. Equipment composition

This equipment is composed of four parts: shot pouring equipment, roller conveyer, screw conveyer and pneumatic system. It is a mechanical, electrical and pneumatic integrated equipment. With a little adjustment, the cylinder block and cylinder head of four or six cylinders can be disposed according to the requirements, and the power can meet the requirements of the main engine.

3. Mission principle

The workpiece to be shot blasted by the starting and ending shot blasting machine comes out of the loading and unloading station, the starting and ending roller conveyer and the shaft roller on the turntable enter the shot pouring equipment, and the continuous orientation is controlled by the photoelectric switch; The clamping cylinder in the shot pouring equipment clamps and fixes the workpiece; Drive the reduction motor to drive the rotary table to rotate and dump the remaining shot material in the workpiece cavity; The shot material will fall into the collection bucket below, and be transported out by the screw conveyor at the beginning and end, and will fall directly into the belt conveyor in the trench; After about 20-40 seconds from the beginning to the end (change 3-8 circles), the turntable is continuous; Clamp the cylinder to loosen the workpiece; The pneumatic motor drives the shaft roller on the rotary table to transport the workpiece out. In addition, the next workpiece enters the shot pouring equipment and repeats the above process. The movement of each part of the whole equipment is controlled by the host.

The mission of shot blasting machine enterprises is to deal with the coexistence of independent enterprises for many years

At the time of the establishment of the shot blasting machine enterprise, the industry insiders had tested that the development strategy of the shot blasting machine industry was carried out with the breakthrough big thinking and big pen, and tried to create an elite team of the shot blasting machine industry in the development process. After three to five years of efforts, the shot blasting machine enterprise was built into a modern industrial shot blasting machine enterprise that meets the national development requirements, but it has not been completely completed.

At present, the central task of shot blasting machine enterprises is to break the relatively independent and independent management system of enterprises for many years to a considerable extent. Through business process reengineering, shot blasting machine enterprises can optimize the allocation of domestic and foreign product technology, human resources, marketing network, capital, processing equipment, plant land and other soft and hard resources, so that the integration has a multiplier effect.

The workpiece to be shot blasted by the shot blasting machine comes out of the loading and unloading station, and the starting and ending roller conveyor and the shaft roller on the rotary table enter the shot pouring equipment, and the continuous orientation is controlled by the photoelectric switch; The clamping cylinder in the shot pouring equipment clamps and fixes the workpiece; Drive the reduction motor to drive the rotary table to rotate and dump the remaining shot material in the workpiece cavity; The shot material will fall into the collection bucket below, and be transported out by the screw conveyor at the beginning and end, and will fall directly into the belt conveyor in the trench; After about 20-40 seconds from the beginning to the end (change 3-8 circles), the turntable is continuous; Clamp the cylinder to loosen the workpiece; The pneumatic motor drives the shaft roller on the rotary table to transport the workpiece out. In addition, the next workpiece enters the shot pouring equipment and repeats the above process. The movement of each part of the whole equipment is controlled by the host.

If you want to know more, you can read our website, and we will provide you with better information!