Shot blasting effect of H-shaped steel

The shot blasting effect of H-shaped steel is a surface manifestation after using the shot blasting machine. The H-beam through-type shot blasting machine adopts a roller table for conveying. The length of the roller table can be customized according to the size of the steel cleaned by the customer. The profile steel is hoisted on the front and rear rotating roller table, and the transmission chain is driven by the frequency conversion motor to transport the profile steel to the shot blasting room. Then, the steel surface is shot blasted from different angles by four sets of shot blasters, four at the top and eight at the bottom. The shot blasting strength can be controlled by controlling the travel speed and the size of the steel shot, The passing shot blasting machine has a high degree of automation and is suitable for mass production.

The H-beam through-type shot blasting machine is an automatic shot blasting equipment. The roller table is continuous. As long as it is for H-beam, do we know the operation and maintenance of the H-beam through-type shot blasting machine?

Inspection of H-shaped steel passing shot blasting machine:

(1) Check the wear environment of the inner lining plate, shot splitting wheel, directional sleeve, blade and impeller of each shot blaster, and replace them if there is excessive wear.

(2) Check the chamber body and the guard boards in the shot blasting chamber, and replace them immediately in case of serious wear, breakdown, crack and other conditions that hinder normal use.

(3) Check the protective wear sleeve of the roller table in the shot blasting room and the protective sleeve at the end of the roller table, and replace it if it is seriously worn or broken.

(4) Check the damaged environment of the sealing curtain, and replace it in real time if it is seriously damaged.

(5) Check whether all lubricating parts are normal.

(6) Check the abrasion and crushing environment of the shot material, and add a certain amount of shot material.

(7) Check the dust discharge valve of the dust collector and the accumulated environment in the ash hopper, and clean in real time.

(8) Check the abrasion environment of the shot tube, and repair or replace it if it is damaged.

(9) Check whether the cable, air pipe and air duct are normal.